[index] CentreCOM x610シリーズ コマンドリファレンス 5.4.7
モード: 非特権EXECモード
カテゴリー: IP / 経路制御(RIP)
> show ip rip interface [IFNAME]
各インターフェースにおけるRIPの状態を表示する。
IFNAME |
IPインターフェース名。省略時はIPアドレス設定可能なすべてのインターフェースが対象となる |
awplus> show ip rip interface ↓ lo is up, line protocol is up RIP is not enabled on this interface vlan1 is down, line protocol is down RIP is not enabled on this interface vlan10 is up, line protocol is up Routing Protocol: RIP Receive RIP packets Send RIP packets Passive interface: Disabled Split horizon: Enabled with Poisoned Reversed IP interface address: 172.16.10.1/24 vlan20 is up, line protocol is up Routing Protocol: RIP Receive RIP packets Send RIP packets Passive interface: Disabled Split horizon: Enabled with Poisoned Reversed IP interface address: 172.21.10.1/24 vlan100 is up, line protocol is up RIP is not enabled on this interface vlan1000 is down, line protocol is down RIP is not enabled on this interface
■ networkコマンド(RIPモード)で複数のRIPインターフェースを包含する大きなネットワークアドレスを指定した場合、たとえば「network 192.168.0.0/16」で「192.168.10.0/24」、「192.168.20.0/24」、「192.168.30.0/24」の3インターフェースを一括指定したような場合、本コマンドでは該当ネットワーク内のRIPインターフェースは表示されない。該当ネットワーク外でインターフェースのIPアドレス/マスク長とnetworkコマンド(RIPモード)の指定が一致するRIPインターフェース、および、networkコマンド(RIPモード)でインターフェース名を指定したRIPインターフェースは表示される。
ip rip receive-packet(インターフェースモード)
ip rip send-packet(インターフェースモード)
ip rip split-horizon(インターフェースモード)
network(RIPモード)
passive-interface(RIPモード)
(C) 2011 - 2017 アライドテレシスホールディングス株式会社
PN: 613-001613 Rev.R