[index] AT-AR2050V/AT-AR3050S/AT-AR4050S コマンドリファレンス 5.5.1
モード: 非特権EXECモード
カテゴリー: IP / 経路制御(RIP)
> show ip rip interface [IFNAME]
各インターフェースにおけるRIPの状態を表示する。
IFNAME |
IPインターフェース名。省略時はIPアドレス設定可能なすべてのインターフェースが対象となる |
awplus> show ip rip interface ↓ lo is up, line protocol is up RIP is not enabled on this interface eth1 is up, line protocol is up Routing Protocol: RIP Receive RIP packets Send RIP packets Passive interface: Disabled Split horizon: Enabled with Poisoned Reversed IP interface address: 172.16.10.1/24 eth2 is up, line protocol is up Routing Protocol: RIP Receive RIP packets Send RIP packets Passive interface: Disabled Split horizon: Enabled with Poisoned Reversed IP interface address: 172.21.10.1/24 vlan1 is down, line protocol is down RIP is not enabled on this interface
■ networkコマンド(RIPモード)で複数のRIPインターフェースを包含する大きなネットワークアドレスを指定した場合、たとえば「network 192.168.0.0/16」で「192.168.10.0/24」、「192.168.20.0/24」、「192.168.30.0/24」の3インターフェースを一括指定したような場合、本コマンドでは該当ネットワーク内のRIPインターフェースは表示されない。該当ネットワーク外でインターフェースのIPアドレス/マスク長とnetworkコマンド(RIPモード)の指定が一致するRIPインターフェース、および、networkコマンド(RIPモード)でインターフェース名を指定したRIPインターフェースは表示される。
ip rip receive-packet(インターフェースモード)
ip rip send-packet(インターフェースモード)
ip rip split-horizon(インターフェースモード)
network(RIPモード)
passive-interface(RIPモード)
(C) 2015 - 2021 アライドテレシスホールディングス株式会社
PN: 613-002107 Rev.AN