show ip rip interface

モード: 非特権EXECモード
カテゴリー: IP / 経路制御(RIP)


> show ip rip interface [IFNAME]


各インターフェースにおけるRIPの状態を表示する。


パラメーター

IFNAME IPインターフェース名。省略時はIPアドレス設定可能なすべてのインターフェースが対象となる


使用例

awplus> show ip rip interface
lo is up, line protocol is up
  RIP is not enabled on this interface
vlan1 is down, line protocol is down
  RIP is not enabled on this interface
vlan10 is up, line protocol is up
  Routing Protocol: RIP
    Receive RIP packets
    Send RIP packets
    Passive interface: Disabled
    Split horizon: Enabled with Poisoned Reversed
    IP interface address:
      172.16.10.1/24
vlan20 is up, line protocol is up
  Routing Protocol: RIP
    Receive RIP packets
    Send RIP packets
    Passive interface: Disabled
    Split horizon: Enabled with Poisoned Reversed
    IP interface address:
      172.21.10.1/24
vlan100 is up, line protocol is up
  RIP is not enabled on this interface
vlan1000 is down, line protocol is down
  RIP is not enabled on this interface


注意・補足事項

networkコマンド(RIPモード)で複数のRIPインターフェースを包含する大きなネットワークアドレスを指定した場合、たとえば「network 192.168.0.0/16」で「192.168.10.0/24」、「192.168.20.0/24」、「192.168.30.0/24」の3インターフェースを一括指定したような場合、本コマンドでは該当ネットワーク内のRIPインターフェースは表示されない。該当ネットワーク外でインターフェースのIPアドレス/マスク長とnetworkコマンド(RIPモード)の指定が一致するRIPインターフェース、および、networkコマンド(RIPモード)でインターフェース名を指定したRIPインターフェースは表示される。


関連コマンド

ip rip receive-packet(インターフェースモード)
ip rip send-packet(インターフェースモード)
ip rip split-horizon(インターフェースモード)
network(RIPモード)
passive-interface(RIPモード)



(C) 2012 - 2021 アライドテレシスホールディングス株式会社

PN: 613-001763 Rev.AQ